RIFF ad-lib - Rgsound Online Store · PDF fileBASS The BASS function can be used to adjust the...
Click here to load reader
Transcript of RIFF ad-lib - Rgsound Online Store · PDF fileBASS The BASS function can be used to adjust the...
ESORDIO series
OWNER MANUAL
RIFF ad-lib
RIFF ad-lib
2~4 Ω | 2Ch
2~4 Ω | 4Ch
2~4 Ω | 1Ch
2~4 Ω | 3Ch
Ground Car Chassis
Battery PositiveSource Remote
2~4 Ω | 1Ch 2~4 Ω | 2Ch
Subwoofer 3Ch | 4~8 ΩGround Car Chassis
Battery PositiveSource Remote
4~8 Ω
4~8 ΩGround Car Chassis
Battery PositiveSource Remote
Stereo BRIDGE
Stereo + SUB
4 Channel
Mono
Mono
SUB
L
R
L2L1
R2R1
CROSSOVER ADJUSTMENTSHP Set to the HP position when the amplifier is used to drive a tweeter/midrange system. The frequencies below the crossover point will be attenuated at 12dB/octave. To adjust the crossover frequency, rotate the knob which goes from 40 to 250 Hz.LP Set to the HP position when the amplifier is used to drive a subwoofer. The frequencies above the crossover point will be attenuated at 12dB/octave. To adjust the crossover fre-quency, rotate the knob which goes from 40 to 1000 Hz.FULL Set to FULL position when the amplifier is used to drive a full range speakers. The speakers output will have no attenuation on high or low frequencies.
BASS The BASS function can be used to adjust the low frequency response output at 45 Hz.
Audio OggiVia Roma, 70 62100 Macerata (MC) Italy
Tel/Fax: +39.0733.262025SINFONI WORLDWIDE: [email protected]
• Power supply: 10-16Vcc• Input sensivity: 0.1-6V• Output power 4Ω @ 12V: 85Wx4• Output power 2Ω @ 12V: 120Wx4• Output power mono 4Ω @ 12V: 200Wx2• Frequency response: ±dB 10Hz-50KHz• Signal/Noise ratio: <90dB• Dimensions (WxHxD): 280x50x245mm• Weight: 3.4Kg
RIFF ad-lib