Assembly Instructions KEI Ltd © copyright 2010 Building the PicPatch08 with 4.8V battery operation...
-
Upload
letitia-crawford -
Category
Documents
-
view
215 -
download
0
Transcript of Assembly Instructions KEI Ltd © copyright 2010 Building the PicPatch08 with 4.8V battery operation...
PICPATCH 08
Assembly InstructionsKEI Ltd © copyright 2010 www.kei.co.nz
Building the PicPatch08 with 4.8V battery operation only.
Insert Resistors & DiodesR7 22kΩ
Red, Red, Black, RedR5 330Ω
Orange, Orange, Black, Black
R3 330ΩOrange, Orange, Black, Black
R6 10kΩBrown, Black, Black, Red
D0 IN4001…Check band at
top end
D1 IN4001…Check band at
bottom end
D2 IN4001…Check band at
bottom end
D4 IN4001…Check band at
top end
Insert Sockets Connector
IC1 DIL4 SocketIndent at this endLink Pins 1 and 3
of IC2
12x 4way SIL Sockets
J1Stereo Socket
Trim off small plastic posts on bottom side
before inserting.
Insert Capacitors & Terminals
C4 47uF Electrolytic Capacitor
-ve (short) lead this side
+
C1 C2 100nF 0.1uF Capacitors
6x 3 Way Screw Terminals
Place with wire entry side facing outwards.
Check Solder Joints and insert PCB mounting posts
+
WARNING!!Check there are
no solder bridges or dry solder joints
Insert 4x PCB mounting Postsone on each corner of the PCB.
+5 V
Overwrite text with +5V
Peal off the backing tape from each adhesive post and stick the
assembled PCB to a firm base plate.
Insert Microcontroller Chip
+
Micro
+5 V
Insert Microchip with indent at this end and dot indicating pin 1.
Take care leads are straight and do not
bend during insertion
Well done, the PicPatch08 assembly is now complete