Post on 15-Jan-2016
description
1. Introduction
2. CALICE collaboration
3. Calorimeter test beam results
4. Summary
8080
Jaroslav Cvach, Institute of Physics ASCR, Prague
I. A. SavinI. A. Savin
I.A. Savin and Prague physics: 1964-70 πp scattering 1969-79 BIS 1977-92 NA4 1988-90 tagged ν at UNK 1992 Compass
NA4 experiment: Important school for
experimentalists from Institute of Physics
ASCR Faculty of Mathematics
and Physics, CU J. Žáček, J. Cvach, J.
Strachota, P. Reimer, S. Němeček, J. Hladký, R. Lednický, P. Závada
From nucleon structure functions to calorimeters
NA4 (BCDMS) – mainly data analysis
1986 H1 at HERA – read-out electrodes for LAr calorimeters (ECAL, HCAL) Slow control Spacal electronics Data analysis
2001 Calorimeters for ILC Scintillator tile hadron
(electronics, data analysis) SiW elmg. (Si pad sensors)
Dubna, 7.12.2010 2JC, I.A.Savin, 80
CALICE Collaboration –
worldwide calorimeter R&D effort
EUDET – European grant under 6th FP, I3 (2006-10) AIDA – European grant under 7th FP, INFRA (2011-14)
Electromagnetic Calorimeter with W absorber Silicon pads 1 x 1 cm2 0.5 x 0.5 cm2 Scintillator strips 1 x 4 x 0.35 cm3 with MPPC readout
Hadron Calorimeter with steel (W) absorber Scintillator tiles with analogue readout RPC / Micromegas / GEM – with digital readout
Muon Tail Catcher – steel absorber and scintillator strips
Coordinated test beam programme to combine different technologies at the same time and prove Particle flow paradigm
3Dubna, 7.12.2010JC, I.A.Savin, 80
Reconstruct every particle in the event• up to ~100 GeV - tracker is superior to
calorimeter • use tracker to reconstruct e±,±,h± (<65%> of
Ejet )
• use ECAL for reconstruction (<25%>)• (ECAL+) HCAL for h0 reconstruction (<10%>) HCAL E resolution still dominates Ejet resolution
But much improved resolution (only 10% of Ejet in HCAL)
PFLOW calorimetry = Highly granular detectors (CALICE) + Sophisticated reconstruction software
4
Jet Energy (GeV)
Jet
En
erg
y R
eso
luti
on
/E
jet (%
)
PFA simulation
ILC goal
ATLAS simulationH1 measured
ALEPH measured
CDF measured
DREAM measured
q
q̄
5
Dubna, 7.12.2010JC, I.A.Savin, 80
Calorimeter ZOO
6
Muon trigger
Data recorded:•2006 – DESY, 2006-7 -
CERN•2008-9 – Fermilab•Si-W and Scint-Fe ECAL,
AHCAL, TCMT• e± 1-50 GeV, ± , ± 2 - 80 GeV• Various impact points &
angles of incidence 0°, 20°, 30°, 45°
Envisaged tests:•2010-11 – Fermilab, Digital
HCAL •2010-11 – CERN, AHCAL with
W absorber + 1 plane with Micromegas
17648 read-out channels
Dubna, 7.12.2010 7JC, I.A.Savin, 80
Absorber 30 layers of W: 1.4, (0.4 X0),
2.8 and 4.2 mm thick 24 X0 in total
Active Element 30 layers of Si diode pads
1 cm2, 525 µm thickness6480 channels
~ ½ sensors from Czech Rep. – Prague main contribution
Read-out by ASIC Large dynamic range Auto-trigger on ½ MIP On chip zero suppress Ultra-low power « 25 µW/ch
In beam 2006 - 8Dubna, 7.12.2010JC, I.A.Savin, 80 8
Measured linearity and resolution of energy as response to electrons
Detector performs as expected from simulations
nonlinearity<1%
Energy resolution =16.5%/sqrt(E)+1.1%
Longitudinal shower profiles
Dubna, 7.12.2010 9JC, I.A.Savin, 80
Absorber• 38 layers of steel, 2 cm thick• 4.5 λint in total
Active element Scintillator tiles 3x3 – 12x12 cm2
with embedded WLS fibres Multi-pixel Geiger mode photo-
diodes (SiPM, MPPC), B-field proof, small, affordable, integrated
Read-out by ASIC 2 gains (normal, calibration) HV settings for SiPMs Shaping and multiplexing Power consumption 200 mW/5 V
Calibration and monitoring by LED flashes, temperature rec.
In beam 2006-9
10Dubna, 7.12.2010JC, I.A.Savin, 80
11
Functionalities of the LED system:1) gain calibration at low intensity light2) provide reference pulses monitoredby PIN diodes 3) provide full dynamic range for checking the SiPM response function
Temperature monitored by temperature sensors
∆G/G ∆ T
~ -1.7%/K
12
SiPM response to low LED light
1 LED illuminates 18 SiPM
Cluster finding in HCAL to determine properties of the shower (global) (total energy, volume, longitudinal structure … )Used as input to neural net, training with the MC simulationResolution improved by ~ 25 %
Non-weighted distribution - larger response at higher energies.Sw compensation – linearity back to ~ 2%
Dubna, 7.12.2010 13JC, I.A.Savin, 80
Composition of the Geant4 physics lists for pions All physics lists combine at least two models The high granularity of the calorimeter allows detailed
studies of the substructure of hadron showers in the energy range 10 – 80 GeV
outdated – Geant 3
prefered by LHC test beam data
open to CALICE test beam data
Dubna, 7.12.2010 14JC, I.A.Savin, 80
(E = 25 GeV)Dubna, 7.12.2010 15JC, I.A.Savin, 80
Less short tracks in models, E< 20 GeV
Dubna, 7.12.2010 16JC, I.A.Savin, 80
17
1 m3 – Digital Hadron Calorimeter Physics Prototype
Description
Readout of 1 x 1 cm2 pads with one threshold (1-bit) → Digital Calorimeter 40 layers each ~ 1 x 1 m2
Each layer with 3 RPCs, each 32 x 96 cm2 ~350,000 readout channels Layers to be inserted into the existing CALICE Analog (scintillator) HCAL structure
Purpose
Validate DHCAL concept Gain experience running large RPC systems Measure hadronic showers in great detail Validate hadronic shower models
Status
Construction in 2008 – 09 Tests 2010 - 11
Dubna, 7.12.2010JC, I.A.Savin, 80
Square meter plane with readout boards
π+ shower
1 m1 m33 c calorimeter ialorimeter in n beambeam„Several years of work by a group led by Argonne Physicist Jose Repond (HEP) are paying off, as the Digital Hadron Calorimeter at the International Linear Collider produces incredible detail of hadron showers. For the first time, researchers can measure individual particles in a hadronic jet.“ Argonne today, November 4, 2010
Dubna, 7.12.2010 JC, I.A.Savin, 80
Next challenge: ‣ Demonstrate feasibility and scalability of imaging calorimeters with fully integrated electronics in a real collider detector
‣ Meet the space constraints in a real collider detector
Design of a multi-layers barrel ECAL and HCALEach active layer equipped with readout electronics
Power pulsing
‣ Minimize amount of cables leaving the detector/cracks= Maximize hermeticity
Si-W sandwich29 layers
HCAL
1.5m
ECAL
19
Testing the new calorimeter concept Operation of a 8000 channel system with a novel
photodetector SiPM successful Calibration established Systematic established
AHCAL prototype – a new tool for hadron shower physics Methods developed to identify the first hadron interaction Methods developed to estimate and correct longitudinal
leakage Several simulation models compared to test beam data
SS absorber replaced by W – new data are coming now WHCAL π beam tests November 2010, January-February
2011 Main task – time development of hadronic shower from W
Dubna, 7.12.201020
JC, I.A.Savin, 80