the clean power productio

n

T H E G R E E N E N E R G Y S O L U T I O N

+ =++€/$ EN

ERGY

ΕΝ Ε Ρ Γ

ΕΙ

Α

Stop burning waste gases!

Do you use an industrial flare?Do you burn waste gases?

Do you burn a profit?Flaring waste gases provides no benefit whatsoever. This process

does not negate satisfactorily the damage to the environment and

the degradation of the quality of life for neighboring communities.

Furthermore, valuable revenue that could be obtained through the

use of modern waste disposal technologies is practically burned into

thin air.

Why waste energy and money by using a polluting process?

Today’s technology can turn around this problem and make it a

source of profit in every aspect. Landfills, refineries and the

mining of gas and oil are just a few of the activities that can

take advantage of their by-production of waste gases.

Leading-edge technology permits the generation of

electricity and useful thermal energy from them,

while minimizing, at the same time, their adverse

environmental effects.

Do not burn waste gases! Make money and save the environment.

Clean energy production

offers a range of innovative solutions for energy production

with nearly zero emissions. These solutions revolve around the production of heat and

electrical energy (cogeneration) from a wide range of gaseous fuel sources, including

low quality gas.

Flex Turbine ΜΤ250™The MT250 successfully operates in a variety of environments.

Combined Heat and Power (CHP)The 250kW system provides clean, continuous power to a facility while it

recovers heat for greater efficiency in on site heating, cooling and hot water systems. It is the cleanest burning and most robust gas turbine suitable for

industrial or commercial applications, such as active landfills, refineries, steel industry and any other process that directs waste gases to a torch.

FlexEnergy technology enables customers to generate continuous energy from low caloric value gases while attaining extremely low emissions of NOx,

CO and VOC’s.

Oil & Gas Production

Hydrocarbon fuels can result from many operations along the oil/gas recovery stream. “Raw” gases associated with upstream recovery

operations can often be conditioned for direct use with a turbine. Hydrocarbon constituents can be used as fuel as long as sufficient dew

point suppression can be maintained.

The Flex Turbine™ MT250 operates effectively using a wide range of gaseous fuels. Its ability to adjust the combustion turbine technology,

allows the MT250 to make clean and efficient fuel consumption of a broad spectrum of caloric values - even with gas 30% methane content. Thus,

low-fuel blends (biogas) or too high in energy (natural gas) that other technologies are unable to exploit, the MT250 reclaims them.

TURN WASTE TO ENERGY ON A PROFIT!

-DEPRECIATION OF CAPITAL: 1,5 -3 years!-PRODUCTION: 2,2 GW per year!

-(NOx, CO, VOCs) emissions: < 5ppm!-Low maintenance costs!

-Movable to the next site when needed!

the

prob

lem

the

solu

tion

A complete and effective system that converts

the wasted energy into profitable clean energy

with almost zero emissions.

THE CLEANEST COMBUSTION TECHNOLOGY AVAILABLE TODAY

Clean energy production

offers a range of innovative solutions for energy production

with nearly zero emissions. These solutions revolve around the production of heat and

electrical energy (cogeneration) from a wide range of gaseous fuel sources, including

low quality gas.

Flex Turbine ΜΤ250™The MT250 successfully operates in a variety of environments.

Combined Heat and Power (CHP)The 250kW system provides clean, continuous power to a facility while it

recovers heat for greater efficiency in on site heating, cooling and hot water systems. It is the cleanest burning and most robust gas turbine suitable for

industrial or commercial applications, such as active landfills, refineries, steel industry and any other process that directs waste gases to a torch.

FlexEnergy technology enables customers to generate continuous energy from low caloric value gases while attaining extremely low emissions of NOx,

CO and VOC’s.

Oil & Gas Production

Hydrocarbon fuels can result from many operations along the oil/gas recovery stream. “Raw” gases associated with upstream recovery

operations can often be conditioned for direct use with a turbine. Hydrocarbon constituents can be used as fuel as long as sufficient dew

point suppression can be maintained.

The Flex Turbine™ MT250 operates effectively using a wide range of gaseous fuels. Its ability to adjust the combustion turbine technology,

allows the MT250 to make clean and efficient fuel consumption of a broad spectrum of caloric values - even with gas 30% methane content. Thus,

low-fuel blends (biogas) or too high in energy (natural gas) that other technologies are unable to exploit, the MT250 reclaims them.

TURN WASTE TO ENERGY ON A PROFIT!

-DEPRECIATION OF CAPITAL: 1,5 -3 years!-PRODUCTION: 2,2 GW per year!

-(NOx, CO, VOCs) emissions: < 5ppm!-Low maintenance costs!

-Movable to the next site when needed!

Install now Flex Turbine

MT250™ to produce ultra-clean electricity and

useful thermal energy

T H E G R E E N E N E R G Y S O L U T I O N

the

solu

tion

A complete and effective system that converts

the wasted energy into profitable clean energy

with almost zero emissions.

SCIN AB ScandInvestor AB

Reg nr. SE.556811-1248 www.scin.se / info@scin.se

EUR IBAN: SE77 6000 0000 0000 4500 1529BIC: HANDSESS

SWEDEN Västra Finnbodavägen 2

131 31 NackaP.O.Box 2037,

132 02 Saltsjö-Boo

NETHERLANDS:Benoordenhoutseweg 13,

2596 BA Den HaagP.O.Box 3, 2650 AA Berkel en Rodenrijs

Tel +31 70 314 24 16

Fax +31 10 713 15 63

GREECE:Athens dpt: Mavrogenos 13 Lofos Axiomatikon,

GR-121 36 Peristeri AttikiTel +30 697 285 66 22

Ioannina dpt: Gerakari str 7, GR- 45 332 Ioannina, Tel: +30 26510 21846, Fax: +30 26510 21848

www.scin.se

The Flex MT250 G3 is a complete system for producing electricity and thermal energy with a gas turbine.

The Flex MT250 EXis a gas turbine, which takes advantage of hot air from an external heat source to produce electricity.

Advantages of a Flex Turbine™ MT250

• Generates reliable power that provides energy security and the ability to supply electricity to priority loads in the event of a grid outage.

•  Has a long-term field operating record in diverse applications and environments.

• Contains an internal waste heat recovery system that results in a compact footprint.

• Provides heating/cooling capability in addition to electricity resulting in energy savings over time.

• Hedges against increasing electricity prices by ensuring predictable costs.

• Increases power output in colder temperatures.

• Performs in the harsh environments due to its durable, rugged design.

• Has low emissions as a result of its patented low-N Ox combustor.

• Recuperates engine  heat to enhance turbine efficiency.

• Has integrated fuel-gas booster available.

• Is CARB Certified for landfill gas, digester

gas and natural gas

specializes in the

Waste-to-Energy sector, providing commer-

cial, construction and consulting services.

WASTEENERGY is an affiliate of the Swedish

company SCIN AB.

has established a

partnership with EECT-Turbomachinery to

install and service the cleanest power sta-

tions in the market – all manufactured by

FlexEnergy, the leader in renewable, green

and flexible energy production.

copy

right

SCI

N A

B &

SBD

AB ©