Wireless Portable Bluetooth Speaker

Mode No.: SoundBoxUser Manual

Package content

Product overview

Thank you for purchasing the DOSS SoundBox Wireless Portable Bluetooth Speaker

wireless portable speaker.

• One wireless portable speaker• USB charging cable• Φ3.5mm auxiliary cable• Travel waterproof pouch• User manual,Warranty card,Contact card

1. Mode switch: Touch to toggle play mode among Bluetooth,

2. In Bluetooth mode/TF mode, touch to skip backward.3. • In Bluetooth mode,touch to answer or end a call. Touch for 3 seconds to reject a call. • In Bluetooth mode, touch to play/pause your tune. Touch for 3 seconds to disconnect with your device. • In TF mode, touch to play/pause your tune.4. In Bluetooth mode/TF mode, touch to skip forward.5. Volume control:

1

2

3

5 4

introduction

Status indicators

6. Long press to turn the device on and off.7. Auxiliary Φ3.5mm jack devices.8. TF card: Use it for TF card (with music) playback. support mp3,wav,

to FAT32.

9. Charging port: Plug the supplied USB cable into this port to recharge

10. LED charging indicator. • Charging : Steady Red. • Fully charged : Steady Green.

Center indicator/

indicator

Flashing blue

Steady blue

Steady red

Steady green

Indicates that the speaker has entered into the pairing mode and it is ready to be paired

Indicates that the device is successfully paired

Steady red

Steady Green

Indicates that the device has switched to the auxiliary input mode

Indicates that the device has switched to the TF mode

6 7 8 9 10

Pairing the wireless speaker with your smart device

• Use the supplied USB cable to charge your portable speaker directly from your computer or device with a micro USB port.• Make sure that the speaker is fully charged before using it for the

Note:

Remember to note the above point and fully charge your speaker prior to the first use. It will take approximately 2-3 hours to recharge after.

Press & Hold the power button to turn on the speaker. Repeat the steps to turn the device off as well.

LED light will remain RED when charging and turn GREEN once charge completes.

The speaker has a built-in battery saver mode where it will automatically power off if not in use for 15 minutes. This function can be removed with a firmware upgrade. For assistance, please contact: support@dossav.com

•

Preparation

1. Place your smart device and wireless speaker no more than one meter away from each other.2. Press the power button located on the back of the speaker for several seconds to turn it on.3. Set your smart device to “discover” the wireless speaker. Upon powering on, a tone will be heard, the blue LED will start flashing, accompanied by a prompt notifying that the speaker has entered into the pairing mode.4. Enabled Bluetooth on your device and choose DOSS SoundBox from the list.5. If pairing is successful, the LED will change to steady blue and your phone will confirm that the connection has been established. If the pairing process fails after 60 seconds, please repeat steps 1 through 5 described above.6. long press the button , you can disconnect the Bluetooth. Note: If your smart device cannot discover the SoundBox,long press the button and have a try again.

3. Speak with a clear voice right into the built-in microphone located on

may also end the call directly using the command on your cell phone.5. When listening to music using your smart phone, playback will resume

call using the speaker.

Using it with your Echo DotYou can connect the Dot with the speaker using a 3.5 mm auxin cable or Bluetooth. Please use the following steps to set up using Bluetooth:

Note:

Download the Alexa APP, follow the standard setup procedure to get the dot connected to your home Wi-Fi network.

1.

Switch the SoundBox speaker to Bluetooth mode,you can press the ‘play/handsfree’ button for 5 seconds to keep it in pairing status.

2.

Run the Alexa app, tap Menu and then tap Settings.3.Tap the Echo Dot in your list of Alexa Devices, then tap Bluetooth.4.The SoundBox speaker should appear in the list of Bluetooth Devices. If not, press the "play/hands-free" button for 5 seconds and try again. Once listed, tap on The SoundBox speaker to complete the pairing process. To remove the device, return to Bluetooth -> tap the name of the speaker -> then tap "Forget Device".

5.

Voice command will not be able to turn on/off the Soundbox no matter whether you connect it via Bluetooth / Aux cable. It can only translate sound signal. To remove the battery saver option, please contact our customer service at support@dossav.com to remove the function by upgrading the firmware.

1.

2.

Answering and ending a call using your speaker or mobile phone1. When there is an incoming call, the speaker will generate a tone and

Bluetooth

Problem

TF Card

other

Cannot Pair with Bluetooth devices seconds,then have a try to pair it

again

Please select 'DOSS SoundBox' as the default playback device

The song cuts off during playback

Please check if the Bluetooth distance is more than 33 feet or

There is noise during playback Maybe caused by the interference of charging,try to put it in another place and do not charge it during playback

Laptop prompts to install driver This driver is not special for SoundBox,it's for your laptop

contact the computer company or windows

The speaker do not play when the card is inserted,and jump directly back to Bluetooth mode

Check whether the card format is FAT or FAT32. If not, format it to FAT or FAT32.Check the song format. The speaker only supports MP3, WAV

The song cuts off during playback

All the lights are lit and can not be turned off

Customer Service Email support@dossav.com

Use the needle or wire to poke the

There may be a problem with the

the same file

for 5 seconds or contact with the

for help

Product type: Wireless Portable Bluetooth Speaker with Built-in MicrophoneOutput power: 6W x 2Driver unit: 1.5 inch speaker x 2 + 2.6 inch passive radiatorFrequency response: 100Hz-18kHz

Unit weight: 560 gUnit dimension: 6.6 x 2.7 x 2.9 inchWarranty: One-year limited

Power

Warning

Wireless/Networking

• Input:5V 1A

Bluetooth versions• Profiles supported

• Do NOT drop, hit or shake the device.• Do NOT disassemble, repair or modify the Bluetooth speaker by yourself.• Do NOT use cleaning products that contain benzene, solvents or alcohol.• Do NOT expose the Bluetooth speaker to excessive heat or to direct

• Do NOT store the device in a place with high humidity or dust.• Do NOT place heavy objects on top of the Bluetooth speaker.• Do NOT use near a microwave oven or wireless LAN products.

Product specifications

Wonders Technology Co.,LtdEmail:Support@dossav.comFollow us on Facebook: