FOLLOWING INFORMATIONS IS REQUIRED TO BE …compprovals.com/ProductTestingPDF/CA_Handbook_IS... ·...
Transcript of FOLLOWING INFORMATIONS IS REQUIRED TO BE …compprovals.com/ProductTestingPDF/CA_Handbook_IS... ·...
FOLLOWING INFORMATIONS IS REQUIRED TO BE SUBMITTED TO TEST LAB FOR SAFETY TESTING OF
UPS/INVERTORS OF RATING ≤ 5KVA AS PER
IS 16242(PART-1):2014
FOR PARTICIPATION IN COMPULSORY REGISTRATION
(CRS) SCHEME NOTIFIED BY DEITY
Applicant’s name & Address
Manufacturer’s name & Address:
(In Registration scheme)
Test item description UPS/Invertors of rating ≤ 5KVA
Trade Mark
Model/Type reference
Rated current (A) / Rated voltage (V):
Overall size of the equipment : W: mm, H: mm, D: mm
Mass of the equipment (kg): Kg
Marked degree of protection to IEC IPXX
60529
Series Formation Basis, if applicable Models included in this series
Similarities
Differences
Worst Case
Max. Accessories used
Model / sample submitted for testing
Supporting documents for validation Documents Required for each model in
of series formation and selection of
series
sample (Refer Guidelines for Series
Approval of Products for 1. Mains / inverter board layout & circuit
Implementation of “Electronics & diagram
Information technology Goods” 2. Enclosure drawing with material details
3. Power transformer design
4. Appliance couplers
5. Online / Offline
6. Type of input 1Φ/ 3 Φ and DC(Battery)
7. Power components details
8. Operator accessible
9. Type of Batteries & rating
Following conditions to be fulfilled for
series formation as per DeitY guidelines
1. Same rated Input Voltage
2. Same rated output Voltage
3. Same frequency and number of phases at
input/output
4. Same cabinet design & class of construction
5. Same PCB Design and layout
6. Same battery bus voltage
7. Same power transformer rating & design
LIST OF SAFETY CRITICAL COMPONENTS LIST(UPS/INVERTORS OF RATING
≤ 5KVA ) Object/part no. Manufacturer/ Type/model Technical Standard Mark(s) of Supporting
trademark data Conformity. documents
Enclosure
Mains /SMPS
Transformer
X-Y Capacitors MOV/Surge Suppressor,/MCB
if used PCB Appliance
connectors/
inlet, if used Opto-coupler ON/OFF switch Connector/
terminals, if used Power
supply cord Plug Fuses &
Fuse holder Batteries Power devices Internal wire
Notes:
1. A qualified Technical Person is required to give the demonstration of product
and provide clarifications as requested.
2. The sample submitted should be a complete unit, Additional Enclosure if
feasible, Circuit Schematic Diagram, Block Diagram, PCB Layouts, List of
Safety Critical Components (Test Reports from CBTL/BIS/IEC17025
Approved Lab) and Instruction & Service Manual with technical specification.