NT Technology Tool Breakage Detection Tool Length ...

2
Tool Measurement NT Technology Tool Breakage Detection Tool Length Measurement Tool Radius Measurement Single Cutting Edge Monitoring Axes Compensation Laser Control Micro Single NT Laser Control Micro Single NT

Transcript of NT Technology Tool Breakage Detection Tool Length ...

Page 1: NT Technology Tool Breakage Detection Tool Length ...

Tool Measurement

NT Technology

Tool Breakage Detection

Tool Length Measurement

Tool Radius Measurement

Single Cutting Edge Monitoring

Axes Compensation

LaserControl Micro Single NT

LaserControl Micro Single NT

Page 2: NT Technology Tool Breakage Detection Tool Length ...

61 30

23

22,5

98

Technical data

Laser safety classification Class 2 acc. to IEC60825‑1, 21 CFR 1040.10

Laser type Visible red light laser | 630 ... 700 nm | <1 mW

Protection class IP68

Power supply 24 V DC/160 mA

Inputs/Outputs 24 V DC | 0 ... 5 V DC analogue output *

Repeatability Δ transmitter/receiver: <750 mm: 2.9 μm 2σ **

Δ transmitter/receiver: <1500 mm: 5.6 μm 2σ **

Minimum tool diameter ** Δ transmitter/receiver: <750 mm: 210 μm | 137 μm***

Δ transmitter/receiver: <1500 mm: 405 μm | 268 μm***

Test speed (spindle) up to 200.000 rpm

*Option **Depending on installation situation, stability of fixation, distance and measuring mode*** With reduced amplification

Blum worldwideService & Support More than 40 subsidiariesand service offices.

www.blum-novotest.com

Blum-Novotest GmbH | Kaufstrasse 14 | 88287 Gruenkraut | Germany | +49 751 6008-0 | [email protected] Production Metrology Made in Germany

© B

lum

‑Nov

otes

t Gm

bH |

Ver

sion

08|

18,

Subj

ect t

o te

chni

cal c

hang

e w

ithou

t any

not

ice

LaserControl Micro Single NT | Non-contact tool setting system for machine tools

Extremely precise single system for tool setting

and monitoring under harshest conditions

• High absolute accuracy due to focused laser beam

• Measurement at nominal spindle speed

• 100 % process reliability due to patented NT‑Electronics

• BLUM pneumatic unit and shutter system provide superior protection

• Programmable by integrated microprocessor

Your benefit:

• Easy beam alignment due to LED band

• Increased productivity and production quality

• No subsequent damages due to tool breakage

• Reduced set‑up time and unmanned operation

• Reduced scrap rate

Fast single cutting edge monitoring

Complete system with accessories for easy mounting in the machining area

100 % reliable due to BLUM protection system

Indispensable – the BLUM pneumatic unit

Blum-Novotest Ltd.Unit 15 Granary Wharf Business ParkWetmore Road, Burton upon TrentStaffordshire , DE14 1DUUnited KingdomPhone: +44 1283 569691Fax: +44 1283 [email protected]

Blum-Novotest, Inc.4144 Olympic BoulevardErlanger, KY 41018USA

Phone: +1 (859) 344 6789Fax: +1 (859) 344 [email protected]