FONT Meeting1 Charge normalisation and IP LO power scan N. Blaskovic.

FONT Meeting 1

Charge normalisationand IP LO power scan

N. Blaskovic

N. Blaskovic

Contents

• Jitter dependence on charge normalisation(using P3 ΣI, IP reference diode or neither)

• IPC I & Q dependence on LO power level

FONT Meeting 2N. Blaskovic

Charge normalisation

• Calibration and jitter runs taken on 060314• Waist on IPC in Y• Multiple RF variable attenuator settings• Upstream and downstream boards set-up• Results presented:

– Charge normalised using P3 ΣI

– Charge normalised using IP reference diode– Not charge normalised


Charge normalisation

• Charge normalisation appears to worsen jitter, particularly if reference diode is used


LO power scan

• Jitter runs taken on 140314• Waist on IPC in Y• RF variable attenuator set to 10 dB• LO level for IPC(Y) electronics changed by

0-11 dB variable attenuator• I & Q signals in LO power scan presented



IPA

IPB

IPC

Ref splitter

electronics

electronics

electronics

attenuator

RFvariable

attenuator

diode

FONT5 board

(digitiser)

port 1port 2

port 1port 2

port 1port 2

IQ

IQ

IQ

IP BPM C-band signalReference C-band signalBase-band signal

6.4 GHz (y) / 5.7 GHz (x)

hybrid

hybrid

LO var. atten.

LO variable attenuator


IPC(Y) I

IPC(Y) Q

Ref(Y)

LO power scan

• Mixer output should be in region where it does not vary with input LO level; Siwon:


Linear IF output rangedue to LO input

Next steps

• Priority:– Propagate P2 & P3 position to IP waist (MAD)– 0-11 dB variable attenuator path length test– AQF7FF position to IP y’ pitch relation (FS)

• Interesting, but perhaps secondary:– Phase advance along beamline (MAD)– along beamline including MQF1-5X

• Digitiser at IP if 2 boards not available for upstream feedback with monitoring at IP?


FONT Meeting1 Charge normalisation and IP LO power scan N. Blaskovic.

Documents

Transcript of FONT Meeting1 Charge normalisation and IP LO power scan N. Blaskovic.