Blankom DTS 397 ASI Splitter - Toner Cable Equipment

of 2 /2
DTS 397 ASI Splitter 969 Horsham Road l Horsham, Pennsylvania 19044 USA l Phone: 215-675-2053 Fax: 215-675-7543 l [email protected] The active splitter distributes the electrial input data stream (DVB/ASI) to 8 electrically equivalent outputs. DTS 397 is a 19" module requiring 1 rack unit (1 RU) in the 19" rack. One ASI test port is located on the front panel. Six LEDs indicate the operating conditions. At the module's back there are the electrical input and output ports. The device is equipped with 2 power supplies. This makes it possible to operate the device at different circuits if redundancy is needed. According to DVB, the input data stream can be composed byte-wise and/or packet-wise. However, the MPEG-2 data in the ASI signal stream is made available at the outputs as packets. Signal Processing in the ASI interface is done according to DVB, Asynchronus Serial Interface (ASI). Only MPEG data meeting the MPEG-2 standard ISO/IEC 13818-1 is transmitted. Redundant power supply Features MPEG-2 and DVB Compliant Automatic 188/204 byte detection DVB/ASI Input and DVB/ASI Outputs (1 to 8, 1 Test Port) Useful Data Rate 0.1 to 200 MBIT/S Redundant Power Supply 19" Module, 1 RU

Embed Size (px)

Transcript of Blankom DTS 397 ASI Splitter - Toner Cable Equipment

Toner TEHQ6 Encoder Host_TCE CABLE TOOLS.qxdSpecifications Subject To Change Without Notice Rev 04-13 © Toner Cable Equipment, Inc.
969 Horsham Road l Horsham, Pennsylvania 19044 USA l Phone: 215-675-2053 Fax: 215-675-7543 l [email protected]
Specifications
8 x ASI 1 x ASI Test
BNC, 75 Ω, (EN 50083-9)
D-Sub-9 A-Alarm B-Alarm
System Fault, Error Data processing, Datarate < 0,1 Mbit/s, no useful MPEG-2 data, Signal detected, ASI-Redundancy input active
Configuration
• Auto Redundancy input will be switched automatically • Remote Redundancy input controlled by remote switch (Sub-Min-D Contact 4/5)
• ON Redundancy input active (switching in case of input error) • OFF Redundancy input not connected (no switching)
100 VAC to 240 VAC 50/60 Hz, Redundant power supply < 10 Watt
482.6/ 44.45/ 158 ; 19”, 1 RU 3.5 kg